VERY DIFFICULT TO APPLY !!!! READ THE INSTRUCTIONS CAREFULLY !!!! We take no responsibility in the application process
Made to fit the OPLITE GT (or GTR) style bucket seat (make sure your model is the same as the one on the picture).
This is a design inspired by the GT3 Cup Porsche of 2021
If you need a specific design, send us an email at email@example.com and we will work on it.
The seat belt holes are NOT cut on this covering kit (because the holes placement on the seat is approximate from the OPLITE factory). Best is to remove the plastic seat belt pass through pieces before applying the sticker and cut the excess vinyle using a sharp blade. To remove the plastic pieces in the holes, use a flat head screw driver to release both clips on 1 side and the pull it apart. Be carefull not to break these parts as you will not find replacement ones. Practice on the 5th one at the bottom of the seat (between the legs).
This covering kit is hard to apply on the seat and should be applied by a professional.
Place the center part first and use the shape to align your sticker perfectly.
Then place the side parts using the part you placed earlier to guide you
Be careful with the biggest piece and make sure it is aligned properly before finalizing the application.
You will need to use some heat to get the sticker to stick as the shape of this seat is uneven.
Air release vinyl is used for these wrapping kits to help you avoiding bubbles during the process. You can heat up the vinyl slightly to remove creases to some extent.
Apply on a dry and clean surface. Remove backing paper and smoothly apply on your surface.
Covering stickers, they are not designed for peeling off and on after application.
🇬🇧All our stickers are printed on Monomer based Vinyl (if not stated otherwise) and are UV and weather protected (5 to 7 years lifetime ).
🇫🇷Tous nos stickers sont imprimés sur du Vinyle monomère (sauf si indiqué autrement) et sont recouverts d'une protection UV et intempéries (durée de vie 5 à 7 ans).